-
KTV horn tweeter with a 150 × 150 mm front face and an 80 mm magnet. -
KTV 10-inch speaker with an 8 Ω impedance, listed 200 W rating and 140 mm magnet. -
650 nm red cross-line laser module with a listed 5 mW output for alignment and centring. -
24 V linear actuator with a 200 mm stroke, listed 500 N force and a speed of 20 mm/s. -
LT4 self-returning machine foot switch in an aluminium housing with one normally open and one normally closed contact. -
LTH-1/6 self-returning aluminium foot switch with one normally open and one normally closed contact. -
PG7 nylon cable gland for round cables with a 2–5 mm outside diameter, with a compression seal and panel locknut. -
SSW806 6.5-inch woofer with an 8 Ω impedance, listed 80 W rating and a 24 oz magnet. -
SBW424 6.5-inch woofer with a 4 Ω impedance, listed 120 W rating and gold-plated terminals. -
SBW-430 8-inch woofer with a 4 Ω impedance, listed 150 W rating and a 30 oz magnet. -
NEMA 34 closed-loop stepper motor and drive kit with a listed 12.5 N·m holding torque and a 1,000 PPR encoder. -
Vishay TCRT5000 reflective infrared sensor with a phototransistor output for short-range object and contrast detection. -
TFS-201 momentary foot pedal switch with one normally open and one normally closed contact and a 1 m cable. -
Two-way passive speaker crossover boards for separating high and low frequencies, supplied as a pair. -
A four-axis USB motion controller for Mach3, with a maximum step-pulse frequency of 100 kHz. Connection and operating details are listed below.
-
VORTEX HG-750 centrifugal blower for pressure or vacuum service, with a 750 W motor and a listed maximum airflow of 147 m³/h. -
YDT1-16 dual momentary foot switch with two pedals, each with one normally open and one normally closed contact. -
YTUM K11-125 125 mm three-jaw self-centering lathe chuck for compatible spindle mounts. -
50 W neutral-white LED floodlight with a 4000 K colour temperature, IP66 aluminium housing and adjustable mounting bracket. -
ISO20–ER20 collet toolholder for compatible CNC spindles, designed to clamp round-shank tools in an ER20 collet. -
ISO25 toolholder for ER20 collets, made from hardened 20CrMnTi steel for compatible CNC spindles. -
433 MHz wireless remote-control set with 12 V single-channel and 5 V two-channel relay receiver options. -
5718HB56 two-phase NEMA 23 stepper motor with a 56 mm body, 8 mm shaft and 1.8° step angle.
